Rep Power: 0

I am having trouble taking off my stock headlights to replace them with aftermarket projectors. Does the entire front bumper really have to be taken off, or is there an easier way? The only bolt I cant seem to get to is the one that holds it on in the inner part (looking at the car, the bolt that is closest to the front emblem). I cant seem to reach it and I was wondering how I can get to it.

Also, while being an ***, I accidently kicked the plastic part off on my headlamp that bolts on the outer edge of the lamp. I think it can be super glued back on, but is that bolt really crucial for support? Will the lamp throttle around if it is not bolted?

 
Rep Power: 0

Check out the DoItYourself (DIY) section:

Taking out the headlights

this one is for clearing your lights, which will tell you how to take off all the stuff you need to take off to take out the lights. To get those hard to reach bolts you'll need to use a wrench for the tight squeeze.

 
Rep Power: 317

you don't need to remove the whole front bumper, just pull the top forward.

 
Rep Power: 0

What do you mean pull the top forward? On what?

 
Rep Power: 331

ah just remove the whole bumper, not that big of a deal, makes it easier when you're working. theres a bunch of plastic clips underneat and bolts. Just remove all of em, pop off the clips connected to the top grill and your good to go. Pull off the bumper then take off the bolts connected to the headlights. very easy job.

Jeff

 
Rep Power: 0

Mex's way was sooooo easy!!! no need to jack up the car, no need to take all those darn clips off......

 
Rep Power: 0

And best of all, takes like 2 minutes