SDAS Suspension help
Thread Starter
Registered!!
iTrader: (1)
Joined: Sep 2003
Posts: 423
Likes: 0
From: Indianapolis
Rep Power: 0 
SDAS Suspension help
I have a couple of problems
1. SEVERE DRAG ASS SYNDROME
The driver side rear tire sags/tucks more than the other side. I recently put new shocks/struts on the whole car. I also just installed GoldLine springs. Any suggestions?
2. Road Noise. It's not the tires b/c it's done it through 3 different sets of tires. I use to have sh|tty coilovers on and I don't think the ppl who installed them put the suspension back together right, so when I installed the springs I assumed it was correct. Anyway, it also could be the rotors, but it sounds more serious than that. Is it possible to bend a drive shaft? B/C when I start slowing down to stop, it bounces a little bit, kinda like when you have a buldge in the tire.
Nasty on bumps and not aligned...
Where should I start??
1. SEVERE DRAG ASS SYNDROME
The driver side rear tire sags/tucks more than the other side. I recently put new shocks/struts on the whole car. I also just installed GoldLine springs. Any suggestions?
2. Road Noise. It's not the tires b/c it's done it through 3 different sets of tires. I use to have sh|tty coilovers on and I don't think the ppl who installed them put the suspension back together right, so when I installed the springs I assumed it was correct. Anyway, it also could be the rotors, but it sounds more serious than that. Is it possible to bend a drive shaft? B/C when I start slowing down to stop, it bounces a little bit, kinda like when you have a buldge in the tire.
Nasty on bumps and not aligned...
Where should I start??
Registered!!
iTrader: (8)
Joined: Feb 2003
Posts: 1,555
Likes: 0
From: familycar's Moms Room
Rep Power: 299 
If your goldlines are sagging call them and they will replace it for you.
Road noise, sounds like a rotor to me to. did you have it resurfaced last time you installed pads? Or i may be warped. Or maybe a bent rim?
Do you know the model number of your goldlines?
Road noise, sounds like a rotor to me to. did you have it resurfaced last time you installed pads? Or i may be warped. Or maybe a bent rim?
Do you know the model number of your goldlines?
Thread Starter
Registered!!
iTrader: (1)
Joined: Sep 2003
Posts: 423
Likes: 0
From: Indianapolis
Rep Power: 0 Don't have the model #. A shop ordered them adn put them on. I could probably find out. Would they replace them?
I'll probably just buy new rotors and see what happens..I'm sure I need them
I'll probably just buy new rotors and see what happens..I'm sure I need them
Registered!!
iTrader: (8)
Joined: Feb 2003
Posts: 1,555
Likes: 0
From: familycar's Moms Room
Rep Power: 299 Originally posted by speedcreations
Don't have the model #. A shop ordered them adn put them on. I could probably find out. Would they replace them?
I'll probably just buy new rotors and see what happens..I'm sure I need them
Don't have the model #. A shop ordered them adn put them on. I could probably find out. Would they replace them?
I'll probably just buy new rotors and see what happens..I'm sure I need them
Thread
Thread Starter
Honda Civic Forum
Replies
Last Post
