Rep Power: 0

does anyone know how to adjust the sensitivity of the radar sensor in the alpine alarm SEC-150r? everytime the wind blows hard the alarm chirps and the lights blink. im worried it might drain the battery if it happens too much

 
Rep Power: 0

Radar Sensor Adjustment
--------------------------------
1. Press the valet button
2. Press TX+EXT1 on the remote

Outer Sector Adjustment
--------------------------------
3. Press TX to increase sensitivity
4. Press EXT1 to decrease sensitivity

5. Press TX+EXT1 (to switch modes)

Inner Sector Adjustment
-------------------------------
6. Press TX to increase sensitivity
7. Press EXT1 to decrease sensitivity

8. Press TX+EXT1 (to end)



Impact Sensor Adjustment
--------------------------------
1. Press the valet button
2. Press TX+EXT1 on the remote
3. Press the valet button

Warning Stage Adjustment
--------------------------------
4. Press TX to increase sensitivity
5. Press EXT1 to decrease sensitivity

6. Press TX+EXT1 (to switch modes)

Trigger Stage Adjustment
-------------------------------
7. Press TX to increase sensitivity
8. Press EXT1 to decrease sensitivity

9. Press TX+EXT1 (to end)


Hope that helps