Rep Power: 0

Just as the title states, I'm very curious to see if there will be any issues with clearance when I do the swap. I mean I know I have to trim a bit of the radiator support but that should be about it right?

 
Rep Power: 313

Hmm... I don't really know how the supercharger is going to fit but I want to see some pictures when your all done

 
Rep Power: 194

All I know is that the k24 is 19mm higher than the k20

 
Rep Power: 0

That's what I'm worried about. I know the k24 sits 19mm higher but I'm HOPING that the jrsc will fit (it may be tight) with minor cutting.

 
Rep Power: 194

The worst that could happen is you need to cut a hole in your hood and put a fiberglass bump there. People will ask why and then you get to brag about how your engine is so big it doesn't even fit in the car

 
Rep Power: 316

Just make sure to buy an aftermarket hood that gives you more clearance. I don't know how much space you will have for the SC anyways, the K is a tight fir in the car. Doesn't really leave room for much else. I'm sure it can be done. Check out K20.org. they must have more info on this.

 
Rep Power: 0

Looks like the evil plan might just be possible > Currently following a build thread for a k24 + cte blower. We'll see if he can fit in in or not!

 
Rep Power: 0

you should be alright with the ep3 jrsc, i know with a k20 it's been done over and over again