Rep Power: 244

ok . installation has gone amazing .. im using the complete dezod kit .. but the only problem is the wastegate ... im using the tial wastegate and wat have u guys done about the fume hole.. did u guys run a pipe ?? explain .. PLEASE POST PICTURES ...

I also realized that i don't have an intake .. and i wanted to know what u guys have done about that ... i wanted to run a pipe BUT its too tight in there .. i dun even know how it could fit .... can any of u lemme know please ? post some pics so i get an idea of how to do it please

 
Rep Power: 388

I can think of a few ppl that have the tail wastegate, have u searched...?

 
Rep Power: 0

Check my thread (in my sig) for pics of a dump tube. You can either run it open or buy a universal dump tube and have it cut and welded into your downpipe. That's what I did, a lot quieter, but a lot of folks leave it open. Up to you. Keeps engine bay temps down if you plumb it back into the exhaust.

The dezod kit does not come with an intake pipe, so you have to get your own. I cut the bottom part of my old Ebay CAI and used that. It really helps if you relocate your battery to the trunk from an intake pipe space standpoint.

TRIZ just wants you to search because he hates on turbos........

Here, this is quicker.

 
Rep Power: 343

damn speedfoos, your enginebay has no room for ANYTHING.

 
Rep Power: 0

Not quite correct. It has lots of room for more pounds of boost!

Plus there's a little more room over where the battery was. I just couldn't find the pic on my Imageshack page this morning. Here.

 
Rep Power: 304

hehe, i have more room in my engine bay than Clint!!! woo hoo.... but he has more power

 
Rep Power: 244

do you konw where i can get the flange for the tial 38 wastegate didnt come with one

 
Rep Power: 0

Any 38mm WG flange will work for it. Here's one on Ebay for 7 bucks. Just search "wastegate flange" and you'll find a ton of them.

270164644695