Rep Power: 511

it says it is for the 01-04 civic, so i guess it might work unless they just put generic years down. you guys think it will work if i have a charge pipe already? would it be worth $150 for it if it comes with the piping, couplers, and all clamps needed?

 
Rep Power: 0

Probably have to relocate winshield washer reservoir and/or loose A/C and/or ABS


edit...also where is the piping from the TB?


Not worth the $$

 
Rep Power: 511

i already plan on ditching the windshield washer reservoir and i do not have ABS, so that is not a problem. i will probally end up just buying the 4 U bends i was talking about earlier and get the couplers and clamps seperate

and i already ahve a charge pipe, so i dont need a pipe that goes to my throttle body.

 
Rep Power: 511

and with a 2.0-2.5" thick intercooler, i shouldnt have any problems with having to loose the AC condensor

 
Rep Power: 0

^^I think he may have been talking about the a/c compressor, but then again there wouldnt be a reason to keep the condensor either.

 
Rep Power: 584

if u loose the ac u loose the condensor, and the compressor, and in that case u might as well take out all the hoses too to unclutter the engine bay, thats what i did

 
Rep Power: 0

Exactly. I run a 2.5" core with the condensor. I can even run a 3" core if I wanted to.

 
Rep Power: 511

so would these piping work?

 
Rep Power: 327

im sure it would but would need some fab work to make it fit properly. Back on the winshield washer bottle subject. I've found a universal washer bottle cost me $32. I plan on making custom bracket to mount it in the area of the right strut tower and the cruise control box on the firewall. It's made by Anco if your intersted i can get the part number. Im hoping to start on the piping in the next week or 2 if it goes as planned!

 
Rep Power: 327

BTW is that 2.5" pipes or ???? and it sounds like a decent price for including hoses and clamps. Have you seen the clamps it comes with? Has anyone ever made the intercooler piping them self and had the tubes bead rolled on the ends and if so how much did it cost ya?