Rep Power: 0

Alright guys I have an 02 Ex I put eibach sportlines on it, with a camber kit. The camber kit I have isnt enough now to pull it back out to 0 on the front. What have you guys done once the bolt thing on the front ran out of adjustment??? Thanks

 
Rep Power: 380

Sounds like you have the car lowered a whole hell of a lot. Dut dont worry about it, as the OEM spec allows for -.75 deg camber on the nose. 0 Deg is horrible for every thing but drag racing...


You may want to read this...

 
Rep Power: 388

your going to want to rep this guy^

 
Rep Power: 0

Well I just have the eibach sportlines on there which are only supposed to lower 1.4" but they just seem to keep getting lower, I've had them for probably 3 or 4 years now. Anyway last time I get the car aligned they were out of adjustment on the front. So now I really need an adjustment cause the front is wearing my tires out on the inside and I just swapped it to the back which is even worse camber so I need to get it adjusted. But I dont have anymore adjustment on the front. So what can I do?

 
Rep Power: 424

Thats toe, not camber. Camber doesnt really "eat" tires, its the toe that does it.
Post the specs or scan the sheet from the shop.
On the other hand, if you've had the same tires for 3 years, yes, they'll show camber wear and there isnt much you can do about that other than replace em.

I'd say anything less than -1.5 degrees on the front is fine for daily cruising.