Rep Power: 0

So, What has to be done to make this bar fit properly? I searched I didn't really find a DIY or explanation. Will it bolt directly or will I have to modify something?

 
Rep Power: 431

You need to remove 1 wire cover (its useless) and then the bar fits. If you want to use the body mounts you need to epoxy or JB weld in nutserts and then you can bolt it in. The right side needs a little dremeling to get the hole open (there's some kind of bracket inside the rail blocking the hole).
But other than those 2 little things, it fits like a glove.

http://www.7thgencivic.com/forums/sh...ighlight=cusco

Search button works fine.

 
Rep Power: 0

I searched, but for some reason that thread didn't come up earlier...Thanks!

 
Rep Power: 424

I know there's a DIY... cuz I wrote it in April when I had it imported. Search the suspension forum... it should be there.

 
Rep Power: 0

Ok...Thanks so much guys

 
Rep Power: 403

i put it in and i didn't know how the hole on the right side was compleatly covered, i dont' have a a dremel, and i don't know where to get those bolts, the bolts that came with the bar don't fit in the first place...