Burning Oil issue on 2000 EM1
Burning Oil issue on 2000 EM1
so while driving sometimes and always after vtec a little bit of smoke comes out of my exhaust. I have been keeping a eye on oil and i need a qt a week. I drive around 50 miles a day and 35 of those are freeway miles going 80mph so my rpm is pretty high.. Also my car smells like oil/gas but i do have a flowmaster exhaust and DC headers. I just bought the car a month ago so idont know if this is normal. I did have a oil leak when i first bought it and got my cam seal and valve cover gasket changed. I think it might be my head gasket leaking or something?
Joined: Aug 2003
Posts: 21,620
Likes: 1,252
From: Las Vegas, NV
Rep Power: 512 










Re: Burning Oil issue on 2000 EM1
holy ****.. I was losing a quart every 1000 and was freaking the hell out. My vote goes for rings, as well.
Before you go and rip the engine apart, look around for physical leaks. In the meantime, keep the engine oil level in the happy zone.
Before you go and rip the engine apart, look around for physical leaks. In the meantime, keep the engine oil level in the happy zone.
Re: Burning Oil issue on 2000 EM1
I went ahead and checked for leaks again and I can see a tiny leak from the head gasket on the left side and also seems like some of the hoses are leaking a tiny bit too. Im gonna have my mechanic change the head gasket and take off and clean up the hoses. He also said its a good timing to change the water pump and do a valve job. And it seems like a couple of the motor mounts are broken. He told me no to get the cheap ones off ebay but I don't want to spend 300$ for new mounts. Any sugggestions?
If you think a good mechanic is expensive, try hiring a bad one
Joined: Dec 2011
Posts: 32,017
Likes: 256
From: Midwest. Aiming about mid-chest
Rep Power: 518 










Re: Burning Oil issue on 2000 EM1
and I can see a tiny leak from the head gasket
The head gasket does not leak oil.
(Did you mean the valve cover gasket?)
Your problem is stuck oil rings--- and the head must come off to do anything about the rings. Put all new gaskets on when it goes back together.
I would not waste time and money on a head gasket job alone. Pull the pistons out and do the rings while the head is off.
I would not do a valve job if it is not needed.
He told me no to get the cheap ones off ebay but I don't want to spend 300$ for new mounts. Any sugggestions?
Cheap mounts will cause you to feel a whole lot of engine vibration.
I'd say factory all the way.
Thread
Thread Starter
Honda Civic Forum
Replies
Last Post
zaboomafoozarg
Mechanical Problems/Vehicle Issues and Fix-it Forum
13
May 30, 2015 09:21 AM
What_It_Do
6th Generation Civic 1996 - 2000
3
May 10, 2015 05:31 PM
markp94
Mechanical Problems/Vehicle Issues and Fix-it Forum
7
Apr 30, 2015 09:19 PM





