Rep Power: 0

i just got some codes pop up on my scanner

permanent code TDC, P1361 cam sensor. Is need to be change ?i am hearing a noise after i rebuilt the engine and put everything back together and this code explained something about noise to so i might need to check my timing again before things get worse.

P0113 IAT sensor circuit high voltage

and the other is a Cat code which i already know about.

this IAT one needs to be change as well or it can be dealt with some other way?

some pros advise needed here pls.:

 
Rep Power: 120

Straight off the WWW thingy.

• IAT is bad, and needs replaced.
• IAT is good, but oil has contaminated it (on the tip).
• Wiring harness has been damaged/shorted.
• Backfiring has occurred in the intake manifold. This can fry/contaminate the sensor.
• PCM failure.

Dint forget the obvious, did you actually plug it back in..

 
Rep Power: 0

Yes, I plugged it back in..

 
Rep Power: 245

Check wiring and pull the sensor and see how it looks.

 
Rep Power: 0

Ok...