Detroit, lets start a list of cruisin' and car show spots for this spring and summer.
Registered!!
Joined: Apr 2001
Posts: 1,032
Likes: 0
From: Stankonia, Michigan, Michigan, US
Rep Power: 0 
its not hard at all to install the lights...Go to the DIY and look at the directions on how to remove the bumper...you have to take it off in order to remove the headlight casing....Not very hard at all!!!
Patience is the key...It took me 15 min to remove my bumper...2 hours to clear...15 min to re-install...
So if you buy those off Edgar...maybe 45 min tops!!!
Patience is the key...It took me 15 min to remove my bumper...2 hours to clear...15 min to re-install...
So if you buy those off Edgar...maybe 45 min tops!!!
Registered!!
Joined: Apr 2001
Posts: 1,032
Likes: 0
From: Stankonia, Michigan, Michigan, US
Rep Power: 0 
I'm back in Bloomfield for the week...Too bad its freakin cold out...I wanna paint some more of my interior...but its not gonna happen with it like this...I might go buy all the material...and start working on my setup in the truck area of the car...
Thread Starter
Registered!!
iTrader: (3)
Joined: Aug 2001
Posts: 3,231
Likes: 0
From: Metro Detroit, Michigan
Rep Power: 0 
well, if you look under the car, there is no room to hide the spare under there....****, I can not even get neons under my back end cause you will see the buld which I think looks cheap. You will most likely need a new rear bumber or ground effects to hide the spare underneath unless you are sitting low. Also maybe try a spare holder from a truck that you could crank down. Good luck to ya!
Also, how do you guys add your link to your signature? Thanks!
Also, how do you guys add your link to your signature? Thanks!
Registered!!
iTrader: (1)
Joined: Aug 2001
Posts: 923
Likes: 0
From: Southgate, Michigan, US
Rep Power: 0 
xHoteKx if you still want my lights its going to be awhile till i recive my projectors but if you say you wnat them then when i take them off ill make sure your the one to get them. you did understand what i meant when i siad trade mines for your + $40.00 right if you want them sooner maybe i can work something out.
Registered!!
Joined: Apr 2001
Posts: 1,032
Likes: 0
From: Stankonia, Michigan, Michigan, US
Rep Power: 0 
still waiting on shippin of springs from eXNBP!!!
Hopefully soon...!!!!
Went to Pepboys to get interior paint...Lookin to start something new this week!!!
Let you know!!!
Hopefully soon...!!!!
Went to Pepboys to get interior paint...Lookin to start something new this week!!!
Let you know!!!
Registered!!
iTrader: (1)
Joined: Aug 2001
Posts: 923
Likes: 0
From: Southgate, Michigan, US
Rep Power: 0 
Hey platnum.. are you going to be out of school for the summer? and are most of yous going to be able to meet up on woodward this spring , summer etc. on friday nights
Thread Starter
Registered!!
iTrader: (3)
Joined: Aug 2001
Posts: 3,231
Likes: 0
From: Metro Detroit, Michigan
Rep Power: 0 
I should be able to make a lot of fridays. i work till 5:00 but this summer we got all kinds of construction going on so i might be working till 6:00 or so some nights but i should be there. Me and my buddy usually go to the sears car show in lincoln park, then I think we will go to the 50's mcdonalds or woodward depending on how far i want to drive that day. but for sure on fridays i will be doing a car show loop!
i was just thinking....would you guys be interested in trying to get an import thing happening downriver or a little closer than the redline show on woodward? or do you think that there would not be that much interest in one? just a thought.
i was just thinking....would you guys be interested in trying to get an import thing happening downriver or a little closer than the redline show on woodward? or do you think that there would not be that much interest in one? just a thought.
Registered!!
Joined: Apr 2001
Posts: 1,032
Likes: 0
From: Stankonia, Michigan, Michigan, US
Rep Power: 0 
I probably will not be taking classes...I had an interview last Friday for a internship at a TV station up here...It's only a 25 hour/ week job...so I would be around Detroit probably 3 days per week...I will for sure be wanting to meet up...wherever you guys wanna meet...Woodward is the best bet for me...I live off of woodward just north of 16 mile!!!
Registered!!
Joined: Apr 2001
Posts: 1,032
Likes: 0
From: Stankonia, Michigan, Michigan, US
Rep Power: 0 
the interview i had last week was with a gov't TV station up here...seemed pretty sweet...I would be workin in the production and producing part...I have an interview coming up with Fox 17 in Grand Rapids too...That will be my 2nd interview...so we'll see how that goes...!!!
I wanna get the one with the Gov't TV station...The woman who interviewed me is a major MILF!
I wanna get the one with the Gov't TV station...The woman who interviewed me is a major MILF!
Thread Starter
Registered!!
iTrader: (3)
Joined: Aug 2001
Posts: 3,231
Likes: 0
From: Metro Detroit, Michigan
Rep Power: 0 
I love MILF's! LMAO I will tell you this...me and my buddy headed up to Canton and Livonia last night to check out some pool halls and on the way back I had to turn around in a shopping center...there was a Chucky Cheese there...Lots of MILF's picking up there kids. [IMG]i/expressions/laugh2.gif[/IMG][IMG]i/expressions/laugh2.gif[/IMG][IMG]i/expressions/laugh2.gif[/IMG][IMG]i/expressions/laugh2.gif[/IMG] GOOD LUCK!!! with the job and the MILF
i get kicked out of chucky cheese alot.. have too much fun fookin up the place
and as i leave, i'd do a burnout in the parkin lot (could do it really good n long in my old car)
and as i leave, i'd do a burnout in the parkin lot (could do it really good n long in my old car) Registered!!
Joined: Apr 2001
Posts: 1,032
Likes: 0
From: Stankonia, Michigan, Michigan, US
Rep Power: 0 
geez...I can't remember the last time I was in a chucky cheese...!!!
I wish it would warm up so I could paint some of my car...!!!...I'm working on moving my amp from the back of the fold down seats to the back side of the trunk...I've already cut and mounted a board to hold my amp and the capacitor...Now i just need to rout the wires and mount the amp...I'll post some pics once I finish!!!
I wish it would warm up so I could paint some of my car...!!!...I'm working on moving my amp from the back of the fold down seats to the back side of the trunk...I've already cut and mounted a board to hold my amp and the capacitor...Now i just need to rout the wires and mount the amp...I'll post some pics once I finish!!!
i need to re-wire my amp/sub wires.. its all ghetto rigged, so you can see all the wires n crap.. but, it works for now. just ganna wait til the weather gets warm again, and im ganna redo it
Thread Starter
Registered!!
iTrader: (3)
Joined: Aug 2001
Posts: 3,231
Likes: 0
From: Metro Detroit, Michigan
Rep Power: 0 
Man Platnum, you are really wanting to paint something. LOL Just kidding. I need to mount my amp..amp and sub are just rolling around my trunk. Weather got to cold to finish the right way. Hurry up Spring!!!!!
Registered!!
Joined: Apr 2001
Posts: 1,032
Likes: 0
From: Stankonia, Michigan, Michigan, US
Rep Power: 0 
my system is lookin kinda ghetto rigged too...my capacitor is just floating around...and my amp is wedged between the box and the back of the seats...plus my box looks like shiet cause its not carpeted or painted...I'm gonna work on that too!!!
i mounted my amp ontop of my box.. so my box rolls around the trunk.. n i dont have anywhere to store that rubber tray thing that was in the trunk, so i have that still in there
. i really need to mount my box
Registered!!
iTrader: (1)
Joined: Aug 2001
Posts: 923
Likes: 0
From: Southgate, Michigan, US
Rep Power: 0 
<< i get kicked out of chucky cheese alot.. have too much fun fookin up the place
and as i leave, i'd do a burnout in the parkin lot (could do it really good n long in my old car) >>grow up son
Registered!!
Joined: Apr 2001
Posts: 1,032
Likes: 0
From: Stankonia, Michigan, Michigan, US
Rep Power: 0 
<< i mounted my amp ontop of my box.. so my box rolls around the trunk.. n i dont have anywhere to store that rubber tray thing that was in the trunk, so i have that still in there
What rubber tray thing are u talking about??? Did u get an all-weather add on or something...or am I missing something!!!
Stylin...have u gotten those rims back yet from gettin powdercoated???
If so...post some pics...!!!
its just this rubber tray thing that fits right into the trunk.. its supposed to protect the carpetting from mud n stuff.. i might of came with my mud gaurds or something, i duno.. it was just in there when i picked up my car.. wasnt even expecting it.. come to think of it, i ordered mine without mud gaurds too.. odd...
Registered!!
Joined: Apr 2001
Posts: 1,032
Likes: 0
From: Stankonia, Michigan, Michigan, US
Rep Power: 0 
haha...
if you don't want that rubber tray thing...I might be interested in takin it off your hands...
I have to haul around alot of shizite back there alot!
I'm outtie...gotta bowl 2nite in my league...
I'm coming back to D-town area for the week...
Maybe c u guys around...Let me know if u guys wanna meet up...Just got reading to do for class over break and work on my car!!!
if you don't want that rubber tray thing...I might be interested in takin it off your hands...
I have to haul around alot of shizite back there alot!
I'm outtie...gotta bowl 2nite in my league...
I'm coming back to D-town area for the week...
Maybe c u guys around...Let me know if u guys wanna meet up...Just got reading to do for class over break and work on my car!!!
i'll sell it for like 40~50bucks or so if you want it.. i dont really want it, makes my box slide all over the place..
list price for trunk tray is 100bucks
Trunk Tray Linkified! (about 1/2 down the page..)
EDIT: i need money to get Razo quick shift for AT.. 53$.. so im pretty much selling everything i dont need right now.. **** linkered!
list price for trunk tray is 100bucks
Trunk Tray Linkified! (about 1/2 down the page..)
EDIT: i need money to get Razo quick shift for AT.. 53$.. so im pretty much selling everything i dont need right now.. **** linkered!
Registered!!
iTrader: (1)
Joined: Aug 2001
Posts: 923
Likes: 0
From: Southgate, Michigan, US
Rep Power: 0 
Hey whats up Platnum no i haven't takin them in yet been busy latley im still debating . thinking of selling my rims instead of getting powdercoated. if i can get around $400 just for the rims (like new condition) i can take the money that i was going to get my rims powdercoated and get some other ones [IMG]i/expressions/face-icon-small-confused.gif[/IMG]
hey we should have a little meet this friday or something.. since platnum is in the area, it'll be pretty cool. i dont know where we should have it, but we can all discuss for some place thats close to all of us.
Registered!!
Joined: Apr 2001
Posts: 1,032
Likes: 0
From: Stankonia, Michigan, Michigan, US
Rep Power: 0 
two hours worth of work....little confusion...but looks so much better...no more amp, wires, and cap just laying around rollin in my backseat...
check it out...
New pics at bottom
l8r...Mark
check it out...
New pics at bottom
l8r...Mark


