Rep Power: 0

I want to cut out a square in my glove box so that i can integrate my CD changer into it. Because as you know it wont fit inside and it would look different. I've seen the pic of someone cutting out a space for a playstation. But my question is what tools do you pro's in DIY recommend in doing this so i get a good clean cut without getting jagged edges. The box is basically plastic but is some what thick. thanks guys

 
Rep Power: 337

rotozip or dremel, plus lotsa sandpaper

 
Rep Power: 0

i have a very old dremel that has a cutting blade attachement. But when i look at the blade it looks so thin. Im afraid it might break its like razor blade thin and only about 1 inch in diameter should i use that ? thanks

 
Rep Power: 0

that'll do fine...just cut slowly and be as precise as possible....cut the whole at least 2mm too small on all ends and sand from there for an exact fit..


Cheers
Mohawk

 
Rep Power: 0

sounds good thanks guys [IMG]i/expressions/face-icon-small-blush.gif[/IMG]

 
Rep Power: 0

hey cypher post a pic when done.