Rep Power: 0

i see that the rear licence plate is where most of the rattling is comming from but it's because there are
no damn holes at the bottom screws to bolt it on tight anybody know how i can get this licence plate down
without drilling extra holes into the damn car
instead of having screws i see two rectangular foam peices i guess to stop it from hitting the car ....

how did yall get your plates to stay on tight when u didn't have holes in tha trunk for a screw?

 
Rep Power: 0

there are a lot of ways to fix that common problem, the easiest would probably be to stick somethign behind the liscence plate, like one of those sticky cork things that go on cabinets, so when the plate hits the car, it doens't make any noise.
-Edna

 
Rep Power: 0

yup.. tighten the bolts and put some sticky foam or even 2 sided foam carpet tape on the back [IMG]i/expressions/face-icon-small-smile.gif[/IMG]

 
Rep Power: 0

hmm so 2 way tape should do tha job eh......

k imma get some a try it out ........i wonder if those foam stoppers that are there from factory are gonna make any mess

 
Rep Power: 0

the foam stoppers should be doing the trick.. Now are you postive it's the plate itself that's rattling or is it the trunk latch?

 
Rep Power: 0

I have the same problem but it is coming from the plastic trim from the dealer hitting the plate. I think that is the only rattling I am hearign right now, but I will have to wait and see since I have only had my subs in for about 5 days now.

 
Rep Power: 341

i used sponge for the same problem. but then another problem came from it. when i washed my car, the sponge would soak up water. so when i'll be driving around, water would drip from it and i'd have UGLY water streaks goin down my trunk so i just took em out, and im going to replace them with one of those rubber stopper thingys.

 
Rep Power: 338

rubber weather stripping. works great, used a #$(* load cause i had it on hand

 
Rep Power: 0

use dynamat, water doesnt effect it.

 
Rep Power: 0

double sided tape! [IMG]i/expressions/beer_yum.gif[/IMG]

 
Rep Power: 0

i used common sense

 
Rep Power: 0

Dynamat has a license plate cutout you can buy for like 15 bucks just attatch it to the back and happy thumping

 
Rep Power: 0

i have the same prob.. i bought a velcro tape and put the softer side 1 for each corner jst cost me less than 5