Rep Power: 0

how do i take it out i searched for a DIY but i kept getting a 404 error when i loaded it. im installing my system peice by peice and today is time to install tha RCA cables.

 
Rep Power: 291

what yr is your car?If you're wondering how to get everything out, HU and the pocket underneath, this should help.

On my 2003, you have to take off the stuff in the center around the shifter, unscrew that, and then take out the bolts above the cupholder/under the HU/pocket. There should be three screws to my recollection.

then, with all your power, PULL. The whole middle part, where the radio and pocket are, should fall out if you pull hard enough. BTW, You'll be pulling from where you just got the bolts out from, above the cupholder. If you want, wrap a flathead screwdriver with a cloth. Then, loosen the HU/pocket part by prying a bit. then when you pull, it'll come out easier. The first time will be the most difficult cuz its never been done before. [You are wrapping the screwdriver to avoid scratching your interior peices].

Once the HU/pocket are out its pretty simple. Just take the screws off and replace the HU, connect your wires, etc.

Thats a quick summary. I dunno if im missing anything but if ya need any more help you can add me on MSN.

Or PM me or just post here. Best of luck

SiG

 
Rep Power: 0

got it done although i wish i had of seen that wrap it in a cloth sooner hardest part was removing it all. ok ive only got 2 more parts of my system to do, power wire/ground and hooking up the amp to the sub and sub inot the box. alredy wired my remote gain

 
Rep Power: 328

you go through this link for the DIY? I know you said you already got it, but I checked and it works fine:

http://www.7thgencivic.com/forums/sh...d.php?t=153830

 
Rep Power: 786

this DIY is better and works for the better/newer models

http://www.7thgencivic.com/forums/sh...45&postcount=9