Rep Power: 402

ahhh... i found out that my radiator has a small hole in it, and the last few days, ive always been wondering why my car has been warming up fast. i have been seeing wet spots on the floor when i get in my car early in the morning after a long night of parting... anyways, so i turn on my car and i was going to look at my hondata settings and i download the calibration. and it shows the "correct" one. so i was looking at the settings and what not. then i accedently pressed the upload button for 1 second because the stupid lapton has the tracpad set to click when you tap it... i haven't used this laptop forever, so i called my the guy that dyno tunned my car and im waiting to see if there is a back up dyno... god im a idiot, so i go back into my house and i see there is radiator fluid squirting out... ahh... i checked the fluid level and there is a tiny bit left... ****.

so i need a new radiator... any suggestions... preferably upgraded... and i need to mess with the hondata again.

i loaded the calibration and it runs really ruff

 
Rep Power: 0

you could plug it, theres an additive you put into your coolant that will plug any holes you have. id say new rad but just incase you didnt know....

 
Rep Power: 0

i think fluidyne makes radiators for our cars. I know a couple people who have them on other cars and they have no problems

this is helpful
www.radiatorinfo.com
also this
http://www.balkan.com/spi_radiator/R...HONDACIVIC.htm

 
Rep Power: 402

i need one made for a 02+ si(ep3)

 
Rep Power: 358

KOYO, PWR, FLUIDYNE & C&R make aluminum Radiators

 
Rep Power: 358

Here is a comparison of a stock 02 si raditor and the C&R radiator

http://www.superstreetonline.com/pro...2_skunk2civic/

 
Rep Power: 361

jun has the c&r ...

 
Rep Power: 379

there is a guy on ebay who makes custom radiators. and they are actually really nice your lloking at like 3x the cooling capacity. my neighbor bougt one for his allmotor D16 and its works really well. dropped his tempratures by about 30 degrees. and i think it cost all of $220.

 
Rep Power: 0

not trying to be a smart but why not just get another si radiator?

 
Rep Power: 330

^its usually cheaper to go aftermarket, and aftermarket usually has its perks..like capacity and efficiency.

 
Rep Power: 0

oh then i would get koyo if they make one lol

 
Rep Power: 402

yea, thats what im lookin in getting

 
Rep Power: 297

yeah I did the same mistake with my emenage and my tune. The best thing to do is save it to your PC and then if someothing like that happenes you just upload it from the hardrive

 
Rep Power: 402

yea, apparently he gives you a copy of your program 9if u need it but the tunners laptop crashed. freaking A

 
Rep Power: 335

i know that he can load the software to your comp and you can reload from your back up. and i know that the software is expensive as hell but get him to do it if you need it bad. good luck with that. did you find out how the whole came about? or how a rick could get up and into that radiatior?

 
Rep Power: 0

get a Koyo...I have it and love it....its bling bling also