Rep Power: 0

i was wanting to do a k20a and was trying to figure out what else i will be needing if i ordered this engine http://www.naganojapanese.com/k20a.php off that website. thanks

 
Rep Power: 512

yes, and read this

http://www.7thgencivic.com/forums/sh...d.php?t=141122

 
Rep Power: 0

i've read the entire faq thread, i understand i need the mounts and powersteering from the Si and Subframe and such but that website has stuff with the swap like suspension and other stuff like that. i was wondering if since im getting a JDM engine if i need other special stuff that i cant get off a RSX-Type S front clip ( I.E.- KPH to MPH)

 
Rep Power: 363

if you're keeping 4 lug ... get Si axles. If you going 5 lug with type S suspension, get type S axles ... if you're going 5 lug with type R suspension, get type R axles.

 
Rep Power: 0

do i just need to take the speed sensor off the type s for the mph conversion

 
Rep Power: 363

what? ... you don't need anything like that.

 
Rep Power: 413

 
Rep Power: 330

you also need to reflash the RHD module

 
Rep Power: 0

Are you even doing the swap urself? Or are you having a shop do it? Cause if your having a shop do it, and you get the engine from them, the vendor usually sends all the parts u need for the engine with it, so you don't have to worry bout it.

 
Rep Power: 0

the reason im askin about the speed sensor is cuz when you do a sr20det swap into a 240 you have to pull the speed sensor off the k24. i was wondering if you have to do that as well with the k20a.

i will be having a shop do the swap and i will be ordering the k20a online cuz they are expensive as hell out here

 
Rep Power: 280

so if yoru having a shop do it...just let them worry about that

 
Rep Power: 0

well you know shops if they dont know what to do then they dont do it and they dont say