Rep Power: 0

Anyone know where the presure sensor on the E-01 Boost controller goes conected to??

Cuz on the diagram it says to the fuel pressure regulator and to the intake manifold........

thanks........

 
Rep Power: 0

when setting boost, let say i whant 6 psi what values should i select for GAIN.......
This is what the manual says for GAIN

This feature is used to stabilize the boost by changing the control valve´s duty cycle. the larger the value the faster the response will be and the lower it is, the response wll be slower. If the value is set too high, the boost will over shot (boost spike). Select this mode and input the desired solenoid duty cycle...


but i dont understand what it really does, or how should i set, it, i has values from 0 to 99