Rep Power: 0

I want to get a turbo but im looking for some answers..

If i get some mandrel bent 2.5 or 3 inches piping, from where to where will it have to be made?

From exahust manifold to the entire back? with out muffler or something?

just the pipe?

 
Rep Power: 0

well what do you have? if you have an EX then u can go from the cat - to the axel. if you have an lx... you can go from the down header to the axel-but then you wont have a cat.

 
Rep Power: 0

and oh yea not sound like a mod.. but this is in the wrong forum.

 
Rep Power: 0

i will make a "CAT section"

a section of the piping i can just swap for emissions tests..

but im not gonna have the cat for daily driving..

mm.. forget my n00bness but whats the axel?

 
Rep Power: 0

its where theres a break in the exhaust... like if you were just to get an axel back exhaust... the flange connects right in front of the passenger rear tire...i say get an axel back exhaust and then get 2-1/4 pipin from the cat to that point .should be no more the 75 bucks for the piping.

 
Rep Power: 0

ok, now i get it..

thanks

 
Rep Power: 0

np

 
Rep Power: 0

you will need it all from where your cat ends (or downpipe - cat) to the rear section.. including new muffler.... this should be done in 2.5" at most in our cars... no need for 3". and unless you ride your car high it will hit EVERYWHERE you go... i hvae 2.5" custom with 2 resonators and the HKS Hiper muffler ( sounds SWEEEET btw)... and i hit a LOT, and no, my resonators ARENT where they can hit... but then again, cars pretty freakin low

 
Rep Power: 0

my car cant be very low because of the streets here are very bad..

also a lot of high speed bumps..

you have a pic of your piping?
HKS hiper muffler is 2.5" too?