Rep Power: 0

Can I fit 35 offset in the rears? I'm not sure cause I don't have the car on me for a while and I won't be able to try it on for testing. I wanna get tires, but it'd be pointless to waste money on tires if the rims don't even fit. I've tried to search, but all I see are 38 offesets. I don't see any mention of 35. Would I need a spacer? Any info would be appreciated. Thanks

 
Rep Power: 424

You don't need a spacer. they're already way out as it is. How big is the wheel and how big is the tire you want to put on it? I put a 215/45/17 on a +37 rim and have no problems.

 
Rep Power: 0

well the rim is 9.5" wide and I'm still shopping for some tires. I just need to know if it'll fit without hitting the arm.

 
Rep Power: 0

holys*** 9.5 you're , with that wide of a wheel you might have a problem. when i go to work tomorrow i'll call our wheel dept. and check on that for you.

 
Rep Power: 0

thanks. I need these wheels cause my 8" wide rims before for my widebody wasn't wide enough. Now that the wide body is going to get pulled out even more to a 6" overall widebody. I def. needed bigger rims. And it just so happened that a company offered to sponsor me with these rims. So now my only prob. is to make them fit.

 
Rep Power: 424

I don't know what offset you're running right now, but figure with an 9.5'" wheel, you're going about another 1/2-3/4" further in from where you are right now, and about 3/4-1" further out than you are right now. So.... figure out where the inside of the rim is now, go in about 1" and see how much room you got. I doubt very much, and make sure you check on the left side that you dont run into any of the fuel system filler stuff.

 
Rep Power: 0

Thanks for the tip. I'll be sure to do some rough estimates on fittings and check for the left side. Thanks for the advice.

 
Rep Power: 350

6"?!?!!? Dayum that thing is going to need its own zipcode!!! Supra-width for cryin out loud!

 
Rep Power: 0

well. it's 6" overall. So basically 3" on each side. I didn't think it was that wide. I was actually thinking of going 4" on each side. Still have time to think about it cause I have about another week till they start fabricating the rear 1/2 of the car.

 
Rep Power: 319

Lucky!!! lol Can't wait to see them.