Rep Power: 0

I have a spare set of 2011 CR-Z wheels I bought because mine came with some curb rash when I bought the car. If I were to put these on the '02 Civic LX, I believe I would need a 4x100 to 5x114.3 wheel adapter if I'm correct. Is there a certain thickness that would be best to keep it around stock wheel placement? The offset on the CR-Z rims 45mm. Specs for the rims are as follows:

Standard on all CR-Z models (Base, EX, EX w/ Nav):
Wheel size: 16×6 Alloys
Tire size: P195/55/16 86V
Bolt Pattern: 114.3/5
Offset: 45
Hub Diameter: 64

The Civic appears to have a 56.1 hub and the CR-Z is a 64. Is this even possible to swap with adapters? May not be. Might be going down an impossible road. Just curious since they're sitting in the corner of the living room.

 
Rep Power: 242

Your going to need hub adapters and by pattern adapters. You may be able to find adapters that do both.

You want as small a spacer as you can unless you want the wheel to stick out more.

It is generally not suggested to use lug pattern adapters.

 
Rep Power: 0

Well from looking around for these spacers / adapters a little bit, it seems they are about 2" thick. Probably not the best way to do that. I think that is mainly to miss the lugs for the adapter when mounting the wheels. Seems like an impossibility.