Electrical Post your Electrical issues here!

Weak cold startup, takes multiple startups to stay on.

Thread Tools
 
Search this Thread
 
Old Nov 12, 2019
  #1  
Eddie Castro's Avatar
Thread Starter
Registered!!
 
Joined: Nov 2019
Posts: 2
Likes: 0
Rep Power: 0
Eddie Castro is an unknown quantity at this point
Weak cold startup, takes multiple startups to stay on.

Looking to find out how to get my car to start up strong in one crank and stay idling.
Reply
Old Nov 12, 2019
  #2  
Colin42's Avatar
"Marge, anyone could miss Canada! All tucked away down there."
 
Joined: Feb 2016
Posts: 9,637
Likes: 1,283
From: Barrie, ON Canada
Rep Power: 222
Colin42 is a name known to allColin42 is a name known to allColin42 is a name known to allColin42 is a name known to allColin42 is a name known to allColin42 is a name known to allColin42 is a name known to all
Re: Weak cold startup, takes multiple startups to stay on.

Need more information.
Cranking slow? Normally?
Check engine light on?
Lots of coughing and sputtering?
Reply
Old Nov 19, 2019
  #3  
99stockcivic's Avatar
Registered!!
 
Joined: May 2018
Posts: 37
Likes: 1
Rep Power: 0
99stockcivic will become famous soon enough
Re: Weak cold startup, takes multiple startups to stay on.

As said above, not enough info to really give specific advice. You need air, fuel, and spark. If it's slow, some guesses are to start with the basic, change plugs, wires, distributor cap and rotor. Then make sure you have a good battery, and make sure you have a good ground strap.

If it has trouble idling, then perhaps it's air, so idle valve needs replacement or cleaning.

Tell us what you have done so far to try and fix it.
Reply
Old Dec 9, 2019
  #4  
Eddie Castro's Avatar
Thread Starter
Registered!!
 
Joined: Nov 2019
Posts: 2
Likes: 0
Rep Power: 0
Eddie Castro is an unknown quantity at this point
Re: Weak cold startup, takes multiple startups to stay on.

Originally Posted by Colin42
Need more information.
Cranking slow? Normally?
Check engine light on?
Lots of coughing and sputtering?
It starts with very low rpm dies after I let the key turn back but if I hold the key turned to the start position it kind of warms it up enough to hold an idle, sometimes i will give it gas to get it to warm up and start and it will sound like popping in my cylinders, after about 15 minutes the idle will go up from under 1k to around 1.5k rpms. Check engine light is on, I’m sure there are vacuum leaks not sure exactly where to start. I haven’t cleaned my fast idle yet or tightened it down
Reply
Old Dec 9, 2019
  #5  
Wankenstein's Avatar
OF top 99.5% creator (Formerly of the Puffinblunts variety)
 
Joined: May 2012
Posts: 3,634
Likes: 109
Rep Power: 210
Wankenstein has much to be proud ofWankenstein has much to be proud ofWankenstein has much to be proud ofWankenstein has much to be proud ofWankenstein has much to be proud ofWankenstein has much to be proud ofWankenstein has much to be proud ofWankenstein has much to be proud ofWankenstein has much to be proud ofWankenstein has much to be proud ofWankenstein has much to be proud of
Re: Weak cold startup, takes multiple startups to stay on.

Originally Posted by Eddie Castro
It the idle will go up from under 1k to around 1.5k rpms. Check engine light is on, I’m sure there are vacuum leaks not sure exactly where to start. I haven’t cleaned my fast idle yet or tightened it down
As always, Puffinblunts recommends a "smoke" test to find vacuum leaks. Rev up your doobies:
Reply
Old Dec 9, 2019
  #6  
Colin42's Avatar
"Marge, anyone could miss Canada! All tucked away down there."
 
Joined: Feb 2016
Posts: 9,637
Likes: 1,283
From: Barrie, ON Canada
Rep Power: 222
Colin42 is a name known to allColin42 is a name known to allColin42 is a name known to allColin42 is a name known to allColin42 is a name known to allColin42 is a name known to allColin42 is a name known to all
Re: Weak cold startup, takes multiple startups to stay on.

Originally Posted by Eddie Castro
It starts with very low rpm dies after I let the key turn back but if I hold the key turned to the start position it kind of warms it up enough to hold an idle, sometimes i will give it gas to get it to warm up and start and it will sound like popping in my cylinders, after about 15 minutes the idle will go up from under 1k to around 1.5k rpms. Check engine light is on, I’m sure there are vacuum leaks not sure exactly where to start. I haven’t cleaned my fast idle yet or tightened it down
What's the engine code? Pxxxx
IAC could be dirty/sticking/bad
Timing could be off
Reply
Related Topics
Thread
Thread Starter
Honda Civic Forum
Replies
Last Post
honudad
Mechanical Problems/Vehicle Issues and Fix-it Forum
1
May 21, 2016 04:35 PM
fearfact
6th Generation Civic 1996 - 2000
2
Nov 20, 2012 01:34 PM
swpowe
Mechanical Problems/Vehicle Issues and Fix-it Forum
5
Dec 26, 2009 05:21 PM
mr_a
Mechanical Problems/Vehicle Issues and Fix-it Forum
2
Jan 18, 2009 04:41 AM
becky23
Engine start problems
5
May 1, 2007 08:46 AM




All times are GMT -5. The time now is 07:04 PM.