Rep Power: 0

Come to find out both corner brake lights not functioning. However the spoiler mounted brake light IS working. Cruise control also not working. The fuse is fine. I replaced the brake light switch but that didn't solve the problem. Where do I go from here ?

TIA

Mike

 
Rep Power: 309

Brake bulbs X 2

If any work your switch is fine.

 
Rep Power: 0

Bulbs were already replaced. The 4 way flashers work so I know the bulbs are fine.Also burnt out bulbs wouldn't explain the cruise control malfunctioning. Something else is going on I just need to know where to look.

 
Rep Power: 309

Your turn signals are separate bulbs and circuit. Signals are single filament. Brake/Tail are dual filament.

If tails are working (same bulb) then check for voltage when brakes applied at the socket and work your way back to 3 way junction point. Wire color = WHT W/BLK stripe.

The sharp tip of a 12 volt test light will allow you to pierce insulation of wires.

 
Rep Power: 0

That junction is located in the drivers side rear side panel?

Mike

 
Rep Power: 309

Don't have the ETM handy for the 7th gens.... but would imagine it would be in the rear area.

When I had the broken wire leading to markers & license lights on the trunk it was all on the passenger side

The 8th gens show it as near the C pillar.

 
Rep Power: 309

From ETM, Connector 601 = 14 Pin, Gray housing, Right C pillar (coupe similar)

 
Rep Power: 0

Not to sound dense, but by right C pillar do you mean driver or passenger side?

Mike

 
Rep Power: 309

Passenger, find the black plastic loom wiring cover affixed to trunk and hinge arm and follow it forward.