Loss of low end torque after PnP d15b vtec !!!
Thread Starter
Registered!!
Joined: Feb 2011
Posts: 5
Likes: 0
Rep Power: 0 
Loss of low end torque after PnP d15b vtec !!!
Hello everyone.
Ok first of all thanks to anyone who can answer my question.
I have a 95 civic with a jdm d15b vtec in it
I did a head gasket job and while i had the head out i did a port match on it
But my problem is i lost low end torque and throttle reponse eventhough in high rpm i can feel a signifigant gain in hp .
My question is, is there anything i can do to get that lowend torque and throttle response back up.
Iknow my port matching was dead on and even ive do t it with friends back in the day but we always were doing turbo setups so i didnt know i would lose the Low end torque
Thqnks in advance
Ok first of all thanks to anyone who can answer my question.
I have a 95 civic with a jdm d15b vtec in it
I did a head gasket job and while i had the head out i did a port match on it
But my problem is i lost low end torque and throttle reponse eventhough in high rpm i can feel a signifigant gain in hp .
My question is, is there anything i can do to get that lowend torque and throttle response back up.
Iknow my port matching was dead on and even ive do t it with friends back in the day but we always were doing turbo setups so i didnt know i would lose the Low end torque
Thqnks in advance
Thread
Thread Starter
Honda Civic Forum
Replies
Last Post
Aznnp77
General Automotive Discussion
0
Dec 13, 2001 04:03 PM
Mokushi
Bolt-on Engine Performance
6
Dec 3, 2001 08:11 PM
