1999 Civic SI power window problem.
Thread Starter
Registered!!
Joined: Nov 2010
Posts: 45
Likes: 0
Rep Power: 0 
1999 Civic SI power window problem.
I have a 99 civic si and there's a problem with the passenger window. It was working up till last night, then nothing. The driver's side work fine and before yesterday, I had to shut the driver's door to bring the passenger window up or down. Now I'm desperate to find the problem. Any ideas. Thanks in advance.
If you think a good mechanic is expensive, try hiring a bad one
Joined: Dec 2011
Posts: 32,017
Likes: 256
From: Midwest. Aiming about mid-chest
Rep Power: 517 
Re: 1999 Civic SI power window problem.
I had to shut the driver's door to bring the passenger window up or down.
Thread Starter
Registered!!
Joined: Nov 2010
Posts: 45
Likes: 0
Rep Power: 0 Re: 1999 Civic SI power window problem.
Finally got the time to check the wires in the door jamb harness and found that about four wires are broken right at the door. Do you know what wire gauge I should use to reconnect the broken wires. Thanks.
If you think a good mechanic is expensive, try hiring a bad one
Joined: Dec 2011
Posts: 32,017
Likes: 256
From: Midwest. Aiming about mid-chest
Rep Power: 517 Re: 1999 Civic SI power window problem.
The original gauge wire was sufficient, but it gets brittle with time and flexing.
You need wire that will withstand repeated flexing.
You need wire that will withstand repeated flexing.
Thread Starter
Registered!!
Joined: Nov 2010
Posts: 45
Likes: 0
Rep Power: 0 Re: 1999 Civic SI power window problem.
I have tried a few scrap yard to find the harness connector without any luck and I can't afford a new floor harness. So can I cut off the two connectors at the door and join the wires.
Thread
Thread Starter
Honda Civic Forum
Replies
Last Post
