Rep Power: 0

Hey I'm replacing the head gasket, valve cover gasket, and almost all the other gaskets on the head of my B16A2 if I have time. I'm also replacing the head studs with ARP head studs, and replacing the timing belt and water pump. I will also be adjusting valve lash.

Just wondering if there where any seasoned pros with some good advice or things to watch out for during any of this. I'm pretty confident I know what to do, but I'm always open to better and safer procedures from people who have been down that road. Any info would be appreciated.

 
Rep Power: 314

Read my started but unfinished head gasket DIY. There is tons of information there... and lots of tips on things. Even though its for a D17 a lot of it is still relevant. Good lucK!