Rep Power: 0

If I'm running 3 amps, 1 (mono) amp, and 2 (2-ch) amps do I have to run 3 power wires, 1 of each guage from the battery and go their own seperate ways from there? Or can I run 1 power wire like 0 gauge to a distribution block and break from there into 1 4gauge and 2 8guage wires?

 
Rep Power: 0

Run only one power lead from you batter to the inside of your car, then use a distrobution block to divide that power lead into more power leads to power your 3 amps.

 
Rep Power: 0

ok that sounds better, buying 3 fuse holders and 3 distribution blocks sounded wallet breaking [IMG]i/expressions/beer_yum.gif[/IMG]

 
Rep Power: 0

can u steer me into the right direction of distribution block made by stinger either HPM series or Expert series?

 
Rep Power: 345

Sound Domain has a good selection of Distribution blocks

 
Rep Power: 0

thezeb.com will charge you less

 
Rep Power: 345

I am having a bad situation with theZeb right now, so until it is rectified and I get the correct item that I ordered from them I won't reccomend them to anyone.

 
Rep Power: 320

The attached pic should help you out.

Put a fuse near your battery like you would for 1 amp then run the power wire to your distribution block in your trunk.
I think I remember reading that its not safe to have a live wire going from your engine bay all the way to your trunk.


Attachments:
[IMG]/forums/themes/orbitz/paperclip.gif[/IMG] Audio Setup.jpg (40 Kb)

 
Rep Power: 337

Lightning Audio makes a block that is 0guage in and has 3 four guage outputs. It is not fused but this is what i use. You can either get in platinum (GD3) or gold (BD3).

 
Rep Power: 350

I'd get one with fuses as well. You can never be too careful. This way there is even less chance of damaging components.

 
Rep Power: 0

here's a good read for you

linked

 
Rep Power: 0

hey man, you really have no need for running all this super expensive high quality stinger cable.... if the install is done well, then it would sound identical with an inferior product... all psychoacoustics after the install

 
Rep Power: 345

Check out this link: Stinger Distribution Block

This is the block that I use, and if you go by the page that OyD posted you won't need a fused block because you will have 4 gauge being split into two 4 guage outputs.