Rep Power: 0

i just got a 70 sq ft roll delivered today.... so when i'm doing the doors should i take that plastic lining thing off? or just put the stuff on top? do i just slap the stuff on right over the wires and all that?

 
Rep Power: 0

i know u guys know the answer....... [IMG]i/expressions/face-icon-small-smile.gif[/IMG]

 
Rep Power: 0

Take the lining off..you have to deaden inside the door too [IMG]i/expressions/face-icon-small-smile.gif[/IMG]..then the door. and replace the plastic thing with the Brown Bread!!

 
Rep Power: 0

so i deaden the actual door..... and the door panel? how many layers on each?

 
Rep Power: 0

2 on the door skin.. 2 on the part where the plastic was.. 1 on the plastic door panel..

 
Rep Power: 0

so what ur saying is i gotta go behind the window? (when the window is down) ok i think i get it (i must seem like a retard)

 
Rep Power: 0

Window up.. the part that would be the outside of the door.. only you deaden ths inside of it

 
Rep Power: 0

Mohawk, I only did two layers on the inner sheet metal (i.e. the door layer where the plastic sheet is stuck to, or the one between the glass and the door interior).

How can you do the door outer skin? There's only a few small holes?

You also did the plastic door panel reverse side?

 
Rep Power: 0

if you have side airbags, then you probably won't be able to get in there!


Aaron

 
Rep Power: 0

The side impact sensor is there right? I thought I saw a contraption of some sort there.

 
Rep Power: 0

Side airbags was an option?.. if you don't have side air bags.. you wedge your arms in there.. cut 6" x 12" trips or smaller and cover that ya can [IMG]i/expressions/face-icon-small-smile.gif[/IMG]

 
Rep Power: 0

Side air bags are standard on the Acura EL!