Rep Power: 332

call me ghetto, but it works. All I did was pull on the taillights until they came out. The clips that go into the middle broke a bit, but everything came out fine. When I had the taillight out I took some wire snips and cut the tab off. The screws inside the trunk and the screw on the bottom are more than enough to hold them on.

 
Rep Power: 0

ok i got it installed, the bumper was easy to take out.. the hard part was putting the lights on.. it doesnt fit perfectly, probably because i paid 65$ total on ebay for it.... right now, there is a little gap on the side by where the bumper is.. oh well i think its looks good and mission acomplished

 
Rep Power: 0

a little gap? if theres a gap make sure u put the bumper back on right, u gotta put it above the black rack. Glad we could help, even though u were a lil annoying and paranoid lol..

 
Rep Power: 0

there was a little gap but o well doesn't really make it a big deal for me as long as the tails look good its fine. o yea i'll post up pics eventually got a pretty busy schedule.

 
Rep Power: 0

a little gap prolly because its waa a cheap set.. but thanks though for helping me, i'm such a n00b, now that i had a chance to take it off, i can see what everyone meant..