Rep Power: 0

I know this is a repost, but am in the middle on an install, and don't got much time:
I was installing my rsx-s 19mm sway bar, and while removing the endlink bolts, i didn't realize you are supposed to use an allen wrench in the end of the bolt. anyways, i just turned the 14mm bolt until the whole bolt and everything was turning! afterwards i saw your supposed to hold the bolt with an allen wrench and then use the wrench to get it off. Anyways, i inspected the rubber boot, it looks okay, do you think the endlinks will be okay? I pried on them pretty hard, and like I said, the hole bolt was was just turning. Please help me....

 
Rep Power: 323

as long as they are not broken you are OK. If you don't have the allen key you can also use a small pair of vise grips and grab the ring in between the boot and the bar. Make sure you don't install it upside down.