Rep Power: 0

Ha! Little problem - how do I detach the harness attached to the bottom of the air intake resonator. I took out the 4 bolts and lifted the resonator, then noticed the harness attached to the bottom. I could not see under there, and felt around a bit, but could not figure out how to detach the harness. Thanks!

 
Rep Power: 0

Alright, well I don't know if you're talking about the same thing that I'm thinking, but if you are...

When we installed a CAI into my EM2 we ran into a similar problem. We took out the four bolts and still couldn't pull the resonator out. Until we figured out that you have to pull that rubber pipe thingy (sorry... I'm not good on technical terms ...) out of the resonator. It holds it in there pretty well, and we just kinda wrestled it out of its housing, and the next thing we know the resonator came out.

I know my answer was vague, and it may not even pertain to your question. But I hope I could help.

 
Rep Power: 0

Was that rubber pipe thingy underneath the resonator? I just want to make sure you don't mean the duct that goes to the air filter box or the air duct on the right fender, by the battery. Thanks!

 
Rep Power: 0

Like... it wasn't the air intake duct. It was like between the box where the air filter is located and the box where the air intake is at. I'm sorry my descriptions suck, I'm just not good with the automotive lingo.

 
Rep Power: 244

http://www.injen.com/galleries/produ...7_05192009.pdf

These are the instructions I used for my install. They might help.

 
Rep Power: 0

Thanks!

 
Rep Power: 0

Thanks! That intake really makes the rest of the engine accessible. I wish they ran the duct to where the original went, above the battery, but I guess the filter won't fit, there.