Rep Power: 354

ok, i am clearing my lights, i have the right headlight in my hand, the DIT says take out the 5 clips woth a flat head screw driver, now, what 5 clips, all i see is 9 things that are like clip, they are black go over the plasic things, but if i try pulling them upwards i bend them? is that ok?? and the silicon is way too hard i have been peeling it of for a while but i am no were, please help

 
Rep Power: 0

There are I think 5 clips on the headlight, I used a flathead and just like a crowbar, just be carful they should slide off with a flathead.

 
Rep Power: 354

by clips do u mean like the ones on the grill which i took off to take the bumper off??

 
Rep Power: 0

The clips are on the headlight, yes you can use a flathead for both things, the bumper, and the headlight you should use a flathead. Use some force and whalla

 
Rep Power: 0

I got confused to when I cleared my headlights when it said 5 clips. I took it as the black clips the hold the headlight together. The silcon will be very hard, the best way that i found how to do mine was to take a shap knife and just start cutting the silcon all the way around the light. Also remember to seal them up good
Jeff

 
Rep Power: 354

yayyy, i finally got it split open, the secret , a BLOW DRYER, [IMG]i/expressions/laugh2.gif[/IMG] seriously that should be added to the DIY

 
Rep Power: 0

...or you could just assume people have a 5th grade education. [IMG]i/expressions/laugh2.gif[/IMG]

 
Rep Power: 0

rofl[IMG]i/expressions/laugh2.gif[/IMG]

 
Rep Power: 0

ya i used a blow dryer, some people used the oven too