Rep Power: 0

Hey everyone, I just got a wire loom kit today to dress up my engine bay and I am having some trouble installing the windshield sprayer tubing. I can connect all the links together fine, but those clips that hold the tubing in place, well I can't get the new tubing to fit through them. Is there a special trick to getting the wire loom in through the clips or do I need to buy some new bigger ones? If I need to buy some new ones, where can I find them? I would really appreciate your help, thanks!

 
Rep Power: 308

Try cutting a small split in your loom, the split will kinda wrap around the clip. This will help hold the loom in place also.

 
Rep Power: 0

I can't do that, if I do then the loom will leak washer fluid!

 
Rep Power: 308

DUDE ! the loom goes OVER the Tubing !

I never seen loom replace the tubing. I dunno Maybe I'm wrong
My loom is over all my wires and tubing.

 
Rep Power: 0

What i did was suck on the end i was trying to put through for a little to get it nice and wet, then stick it in and twist it while your pushing it through.

 
Rep Power: 0

Man WIRE LOOM just goes over the wires or the hoses whatever ur putting i on
did u get wire loom kit or a hose kit???
if u got the hose kit then ur goin to have to run all the hoses again