Rep Power: 268

I just recently Installed some new racing bucket seats but I started the car while my harness was disconnected. How do I reset the Airbag Light? I already tried unplugging the battery. I'm pretty sure that my stock seats did not have the factory airbags built in the seat. There was a thread on reseting the light but I cant find it. PLEASE HELP

 
Rep Power: 271

i need to do this too, when you figure it out..come to square1 and do mine too.

 
Rep Power: 321

Unplug the SRS wire from the fuse box under the dash.
Its the one with the yellow plug.

Take a paper clip and cut it so it is in a U shape.

Insert into SRS plug.
Stick key in ignition and turn it to on (don't start the car).

Within a couple of second the SRS light will turn off.
Take paper clip off.
SRS light will come on again.
Stick paper clip back in quickly.

Can't remember how many times you need to repeat the above steps so repeat until SRS light blinks twice and turns off.

 
Rep Power: 268

Thanks Brother i'll give this a shot.

 
Rep Power: 0

here's a link to the thread where it's posted how to turn off the light. don't know if it works but i'm trying it out tomorrow.
http://www.7thgencivic.com/forums/sh...d.php?t=155251

 
Rep Power: 275

if u have srs it wont work but if u dont its really easy..takes 3 minutes topes

 
Rep Power: 347

The paperclip method worked fine for me

 
Rep Power: 275

http://www.geocities.com/myintegra96/srs.html go there..full directions. im the 1st 04 ex to do it on the list..

 
Rep Power: 0

Just did it and it worked! Easiest fix ever. The speaker wire method was pretty easy.

 
Rep Power: 275

yump.. npp easiest ever.haha u used teh methond i posted? the one i got form that site? that guy was cool we emailed back n forth.. es a good help. i was 1st civic 2 do it..

 
Rep Power: 0

yeah i used the method from that site, thanks. the two methods were the same except the one that you posted said you could use speaker wire and that's what i did. it's alot easier putting two wires together than having to stick two ends into the harness.

 
Rep Power: 242

alright, i just made a post about this myself before i found your post. tried the link and it worked. the hardest part was fitting the wire in the connector. it was dark out and that damn light was all that was on my mind. i even switch seatbelt clip sensors and all. this is just the first day on the site and it's already been a great help. thanks guys.

 
Rep Power: 312

if we actually disconnected the battery before the install and then reconnected it after the insatlltion was all done then would the SRS light still come on?

 
Rep Power: 0

Well my SRS light has been on for about two years now. I reset it and that didnt work. I took the seatbelts out and replaced with 4 point harness. Plugged all the sensors back up and everything. It still wont work. So I dont know how to fix mine.

 
Rep Power: 0

Good **** right there, cant wait to try this after my swap.

 
Rep Power: 0

After you stick the paperclip back in, it should turn back off. At that point, take the clip off and turn off the car and wait 10 seconds. Leave the clip and the MES connector free. Dont attach it yet. Turn the car on, and see if the light has turned off.

Thanks OP for this.

 
Rep Power: 375

^this post is the correct method. the diy is worded really weird.

once the light goes off and the car is running, turn off the car and reattch the honda MES. good 2 go!

 
Rep Power: 0

The paperclip DIY works. Just did it 5 minutes ago. Took me 15 seconds.

 
Rep Power: 0

I recently took my civic to the dealership to have the 90K maintnence performed. The SRS light had been on for months after my wife and I tried to make armrests out of the headrest portion of the seat by removing the hedrest and putting it between the seat and the console, rods first. Long trip. About an hour into the drive the SRS light came on. My wife had taken the car for the maintnence and they told her the SRS sensor in the computer was bad and we had to replace the sensor, which happened to be inside of the control module. Both had to be replaced. I just reset the SRS light in my CIVIC in about 5 minutes. If there was a bad sensor the light wouyld still be on, correct?


SRS Sensor and computrer........ $240
Labor at local Honda dealership......$200

Reseting the SRS light with a staple from a catalog..... PRICELESS

For EVERYTHING else there's 7thgencivic.com

 
Rep Power: 0

this method will work But, How u guys sure that ur seat belt or Air bag will work properly when U get to Accident.. The best thing to do is to reset ur ECU using ur OBD reader..Because u unplag ur wire when u installing ur seat..meaning u dissconnect ur sensor to ur memory...