2nd mod need help
Thread Starter
Registered!!
Joined: Oct 2004
Posts: 7
Likes: 0
From: Tracy, CA
Rep Power: 0 
2nd mod need help I just bought a autometer 5" tach with shift light. I searched and did not see any DIY on a install.... can someone help me I dont like to cut or drill without getting advise and everyone was helpful with the short ram intake.
Please help a noob out
Late
B
Please help a noob out
Late
B
here yah go start here: http://www.autometer.com/tech_installation.aspx hope this helps.
I need TP for my bunghole
iTrader: (3)
Joined: Jan 2003
Posts: 7,103
Likes: 0
From: OXNARD, CA. SoCal. "805", North of L.A.
Rep Power: 359 
the link doesn't work
Use this link or just read below: http://www.7thgencivic.com/forums/sh...d.php?t=155253
Installing a Tach
These are the wires that the author used.
Red line > I put to the 3rd fuse in dash
White line > I put to the right headlight fuse under the hood
Black line > To the chassis as close as possible to the tach
Use this link or just read below: http://www.7thgencivic.com/forums/sh...d.php?t=155253
Installing a Tach
- The four wires from your aftermarket tach are red, green, white, and black.
- The red, white and black should be easy. (See below for suggestions)
- The green wire goes to your test tach wire located by your battery. It looks like a coupling just pull it out and the blue wire is exposed use the green line off the tach to that.
These are the wires that the author used.
Red line > I put to the 3rd fuse in dash
White line > I put to the right headlight fuse under the hood
Black line > To the chassis as close as possible to the tach
Thread
Thread Starter
Honda Civic Forum
Replies
Last Post
ricer_em2
Mechanical Problems/Vehicle Issues and Fix-it Forum
2
May 11, 2016 08:09 PM
Touge
Canada East
0
Sep 22, 2015 11:55 PM
Touge
Ottawa
0
Sep 22, 2015 11:52 PM
