Rep Power: 0

Like my user name says, it is a POS! She is missing her front clip, has no seats, is missing a lot, but I still wanted her so bad I drove over an hour to get her. Wanted one since high school, but was too poor.

This is my first Honda. I am stoked! First area is the engine of course. D-series in her, but prob not for long I hope. Looking forward to scowering the wealth of knowledge on here. This will be a slow build, but once I have the info and parts to start I will start a build thread and post pics.

Looking forward to getting input and making friends along the way.

 
Rep Power: 367

good luck! (from Nashville )

 
Rep Power: 0

Thanks! Happen to know of any local shops or yards for parts worth recommending?

 
Rep Power: 367

the only place i have recommendations for shops is firestone master care close to Hickory Hollow Mall, in antioch - they are the only ones that i found to be good for alignments (custom, included) and very honest on what need to be done on the car (if the tech is still there, that is...)
if not bodywork, i do them myself now that i have a garage to work on

as yards, I look at this site instead of running around:
http://www.car-part.com/

 
Rep Power: 0

I appreciate it.

 
Rep Power: 0

I gathered up some parts- b16a2 head and b18 block. I got some other trim parts too. Haven't has time to do much past that. I decided to keep the d16z6 in her now and just sell the b-series stuff. I still need a front bulk head so prob just roll over the funds into that.

Till then, need to pull that d series out and get to cleaning and planning parts to reassemble.