I.C.E. (Audio) & Electrical Upgrades Post all your I.C.E. (In Car Entertainment) and wiring questions here (Audio, video etc.)

installing cd reciever

Thread Tools
 
Search this Thread
 
Old Feb 14, 2003
  #1  
vince44's Avatar
Thread Starter
Registered!!
 
Joined: Feb 2003
Posts: 2
Likes: 0
From: , Other, ZEBRA
Rep Power: 0
vince44 is an unknown quantity at this point
installing cd reciever

i have a 2001 civic lx coupe with the cassette reciever. i'd like to swap it out with a cd reciever. so far i am going to get my cd reciever from crutchfield.com, they include the adapters free. how hard is it to swap out the reciever and how long would it take? i have never done this before but i am pretty good with my hands.
Reply
Old Feb 14, 2003
  #2  
nucks's Avatar
Registered!!
 
Joined: Jun 2002
Posts: 227
Likes: 0
From: Cincinnati, Ohio, US
Rep Power: 0
nucks is an unknown quantity at this point
depends on how good you are with electronics.....but ordering from crutchfield is a good idea, they have really good step by step instructions and most decks come with a free wiring harness/install kit....if you feel uncomfortable, have a friend help you with wiring, but its not very hard, just take your time
Reply
Old Feb 15, 2003
  #3  
skipbarber's Avatar
ASE Certified Master Tech (A1-A8)
Hey! Look At Me!! I'm a Supporting Member!!
iTrader: (34)
 
Joined: Oct 2002
Posts: 4,248
Likes: 2
From: Rockville, Maryland
Rep Power: 331
skipbarber is a name known to allskipbarber is a name known to allskipbarber is a name known to allskipbarber is a name known to allskipbarber is a name known to allskipbarber is a name known to allskipbarber is a name known to allskipbarber is a name known to all
the hardest part for me was pulling out the console. dont forget to check and make sure you didnt drop any clips while you were struggling to rip that thing out. Same with the bottom console part too. It's easy, not even that time consuming. just be careful not to scratch anything.
Reply
Old Feb 15, 2003
  #4  
DaveyD's Avatar
Mr. Negative
Hey! Look At Me!! I'm a Supporting Member!!
iTrader: (2)
 
Joined: Jun 2001
Posts: 9,165
Likes: 0
From: Duluth, MN
Rep Power: 394
DaveyD is a jewel in the roughDaveyD is a jewel in the roughDaveyD is a jewel in the roughDaveyD is a jewel in the rough
If you follow the Crutchfield sheets, you dont have to pull out the whole center console like it says on the DIY on this site. I ordered the Crutchfield sheets for my rear deck, even before there was the Rear deck DIY on this site. You should be fine, it isnt too hard. The only hard part is popping the radio/AC unit out of the dash. I have learned that it if you push from the bottom where you pop off the plug in, its easier. Have Fun.
Reply
Old Feb 15, 2003
  #5  
liquidblue's Avatar
 
Joined: Jun 2002
Posts: 2,589
Likes: 0
From: Pasadena, CA
Rep Power: 0
liquidblue should not be trustedliquidblue should not be trustedliquidblue should not be trustedliquidblue should not be trustedliquidblue should not be trustedliquidblue should not be trustedliquidblue should not be trustedliquidblue should not be trustedliquidblue should not be trustedliquidblue should not be trustedliquidblue should not be trusted
Quote
[hr]Originally posted by: DaveyD
If you follow the Crutchfield sheets, you dont have to pull out the whole center console like it says on the DIY on this site. I ordered the Crutchfield sheets for my rear deck, even before there was the Rear deck DIY on this site. You should be fine, it isnt too hard. The only hard part is popping the radio/AC unit out of the dash. I have learned that it if you push from the bottom where you pop off the plug in, its easier. Have Fun.[hr]
i don't understand how that could be. each part you need to remove has screws that are covered by the next part back. unless you want to break screws i don't see how it can be removed without ripping out the whole center console. i've installed my stereo, then reinstalled to fix a wiring problem (thanks to my brother) then ripped it out of my car and installed it in my new car.

it's not all easy like in my 94 lx where you had two screws next to the glove box and one below and it was out. that install took 15 minutes.
Reply
Old Feb 17, 2003
  #6  
DaveyD's Avatar
Mr. Negative
Hey! Look At Me!! I'm a Supporting Member!!
iTrader: (2)
 
Joined: Jun 2001
Posts: 9,165
Likes: 0
From: Duluth, MN
Rep Power: 394
DaveyD is a jewel in the roughDaveyD is a jewel in the roughDaveyD is a jewel in the roughDaveyD is a jewel in the rough
I linked a copy of the master sheet. Sorry for the bad scan. Click Me
Reply
Related Topics
Thread
Thread Starter
Honda Civic Forum
Replies
Last Post
mjdiaz89
Mechanical Problems/Vehicle Issues and Fix-it Forum
14
Jun 21, 2016 09:26 PM
OptimisticWay
7th Generation Civic 2001 - 2005
46
Oct 15, 2015 02:16 PM
mrwhos
Introduce Yourself!
4
Aug 11, 2015 02:03 AM
Wankenstein
Mechanical Problems/Vehicle Issues and Fix-it Forum
17
Jul 23, 2015 11:48 PM
EM_WON
Suspension Performance Modifications
4
Jul 22, 2015 06:49 PM




All times are GMT -5. The time now is 09:21 AM.