changing passenger axle seal
Thread Starter
Registered!!
Joined: Dec 2012
Posts: 5
Likes: 0
Rep Power: 0 
changing passenger axle seal
just getting done with a clutch install on a friends 02 honda civic ex however when i pulled the axle the spring on the back of the seal popped off 
so now i have to replace the seal... i pulled the old one out but i havent worked on it in a few days and now i dont remember where the seal sat... is the outer lip supposed to sit flush with case? or does it go in until it bottoms out? also anyone know the best way to bleed the clutch i hear its a bitch and i had to replace the slave because it was leaking.
so now i have to replace the seal... i pulled the old one out but i havent worked on it in a few days and now i dont remember where the seal sat... is the outer lip supposed to sit flush with case? or does it go in until it bottoms out? also anyone know the best way to bleed the clutch i hear its a bitch and i had to replace the slave because it was leaking. 
Thread
Thread Starter
Honda Civic Forum
Replies
Last Post
mrohitredd
Mechanical Problems/Vehicle Issues and Fix-it Forum
5
May 28, 2015 10:03 AM
nymbus2k
General Automotive Discussion
4
Nov 11, 2001 08:53 PM
