Rep Power: 0

sup everyone

im done with tthe swap now the car wont start...im using k-tuned immoblizer bypass...

still using AT dash harness and engine harness... is there any wiring i need to do?

running a MT ECU with AT harnesses

Thanks!!@!

 
Rep Power: 0

check you mailbox.

 
Rep Power: 0

help!the guy that has my car said he hot wire the starter and fuel pump...so it turns over but doesnt start...?

do i need to ground anything or any kind of wiring?

 
Rep Power: 0

tell him to put the wires back the way it was.
the only wires you ground is the two from the fuse box under the steering wheel.
Do that and the car will start.
Thats all I had to do.
is the Green key light flashing when you try to start the car?

 
Rep Power: 0

check you mail

 
Rep Power: 0

the wires I told you is for the Clutch pedal without that the car thinks the clutch is not pushed in and will not start.

 
Rep Power: 0

does it get any power...I think your better off just getting the manual engine harness and keep auto dash harness and ground out those 2 wires under the steering wheel

 
Rep Power: 0

do what gets any power?

well people said i can use the auto harness and all i have to do it ground those 2..hopefully it works

 
Rep Power: 223

Any luck? And have you grounded out the 2 wires in the fuse box under the dash?

 
Rep Power: 0

what 2 wires are you talking about?

 
Rep Power: 125

It’s been 10 years lol