sup everyone

im done with tthe swap now the car wont start...im using k-tuned immoblizer bypass...

still using AT dash harness and engine harness... is there any wiring i need to do?

running a MT ECU with AT harnesses

Thanks!!@!

check you mailbox.

help!the guy that has my car said he hot wire the starter and fuel pump...so it turns over but doesnt start...?

do i need to ground anything or any kind of wiring?

tell him to put the wires back the way it was.
the only wires you ground is the two from the fuse box under the steering wheel.
Do that and the car will start.
Thats all I had to do.
is the Green key light flashing when you try to start the car?

check you mail

the wires I told you is for the Clutch pedal without that the car thinks the clutch is not pushed in and will not start.

does it get any power...I think your better off just getting the manual engine harness and keep auto dash harness and ground out those 2 wires under the steering wheel

do what gets any power?

well people said i can use the auto harness and all i have to do it ground those 2..hopefully it works

Any luck? And have you grounded out the 2 wires in the fuse box under the dash?

what 2 wires are you talking about?

It’s been 10 years lol