Question about front bump stops on 01 with Koni/Eibach.
Thread Starter
Registered!!
Joined: Jul 2005
Posts: 67
Likes: 0
Rep Power: 0 
Question about front bump stops on 01 with Koni/Eibach.
The DIY was very helpful when I installed the Pro-kit with Konis on my 01 coupe. The 01 has a different setup though as far as the bump stops. It is basically a rubber boot with two round stops built into the top of the boot.
If Koni recommends removing half your bump stop, how do you accomplish this without totally destroying this boot/bump stop combo?
If Koni recommends removing half your bump stop, how do you accomplish this without totally destroying this boot/bump stop combo?
Last edited by kool-aid; Jul 19, 2005 at 11:16 PM.
Thread
Thread Starter
Honda Civic Forum
Replies
Last Post
ClapAlongChorus
Electrical
2
Oct 28, 2021 10:50 PM
crowtoo
Mechanical Problems/Vehicle Issues and Fix-it Forum
3
May 11, 2015 06:50 PM
oneheadlight
Mechanical Problems/Vehicle Issues and Fix-it Forum
3
Apr 29, 2015 11:30 PM
GH04si
Mechanical Problems/Vehicle Issues and Fix-it Forum
3
Apr 15, 2015 08:13 PM
