Rep Power: 0

i got 22mm sway bar with energy bushings...
i juss recetly installed grey's endlinks and i started hearing more harsh noises on bumps and all... i juss want to kno if that's normal.. i set up the endlink's lenght to same length as factory endlinks... is it suppose to be that way or is there a certain length to set it in grey's endlinks...

pls i need help.. if u experienced this before pls help me! and tell me how u solved this problem...

 
Rep Power: 0

i think its normal..i get some noise...not alot and not all the time, but sometimes i do...try tightening everything more

 
Rep Power: 403

yea, thats the problem when you get a stiffer suspention. you start to hear things squeek and what not...

it will go away, you will learn to ignore it... i personally think it is worth the money

 
Rep Power: 0

Yeah, I noticed too and I don't have grey's endlinks.

You should ride in my 90 hatchback! Lowered on coilovers, Tokico shocks, front and rear strut bars. I have so many noises, rattles, creaks, it drives me nuts.

 
Rep Power: 0

I've got gray's endlinks and i noticed an increase in squeaks, creaks, and other rattles. Then again i'm pretty sure that my shocks are leaking, which could add to the problem.... there are tradeoffs with a lot of things you can do to your car, some are bearable others will get old really quick.

 
Rep Power: 419

Unlike the stock endlinks, which pack the ball and socket joint in grease and seal it in a rubber grommet, my endlinks are free to float around and do what they wish. I muffled the noise in version #1 with rubber o-rings near the ball and socket joints. This helped a little bit, but it didn't solve the problem 100%.

The stock endlinks are quiet, but they're also weaker and more flexible. People with the Hotchkis endlinks have been having the same problem. Noise. I'm running my endlinks too, and I get some noise as well. I'm constantly improving the design though, and I'm currently working on something that will damped the vibration of the free-floating part.

 
Rep Power: 326

Mine got really bad in the last week or so alone, any suggestions in bringing it back to the way it was when I first installed the endlinks and rsx-s sway? Im thinkin taking the endlinks off, cleaning everything, spraying some white grease on it then tighten it and throw it all back on. Is that the best approach?

 
Rep Power: 419

Hmm... I think you have version #1, right? The ones with the o-rings. I made a version #2 because of that very problem. What happens is that they get dirty and you have to clean them and re-install them for everything to be tight. Dirt gets into the cracks and then it loosens everything up. I might have a solution for you though. We'll talk at Import Wars, ok?

 
Rep Power: 326

yeah man sounds good thanks bro!