Rep Power: 0

any one have a pic of the turboxs RFL bov on their kit ?

 
Rep Power: 0

hope this helps










I know the red pipe and silver is ugly but the kits only been in for about two weeks.

 
Rep Power: 0

nothing ugly about it. It looks 100 times better than a stock motor, lol.

Of course it would look better matching. hehe.

 
Rep Power: 0

Thanks I just need to stop being lazy and buy the paint

 
Rep Power: 310

that BOV is rated at 10 psi and over.

are u boosting 10 psi daily or less?

if u are boosting less, does the valve open up without surging the turbo?

 
Rep Power: 285

if your running less than 10 psi, you should cut a few coils off the spring.

 
Rep Power: 343

How does it feel to be boosted, mesee?

 
Rep Power: 310

about how many coils did u clip?

 
Rep Power: 0

it feels very good to be boosted. especially since i'm one of the very few autos.
I haven't cut any coils off of it because I haven't heard of anyone doing it when I was at 4 psi it let out fine and i'm running 8 psi now. but how many would you suggest to take off???

 
Rep Power: 0

thanks a lot for the pics, but is it wrong if the bov is located next to the o2 sensor of the intake ?

 
Rep Power: 285

i took off about 1/2".

 
Rep Power: 607

I heard that bov on Joel's car at 4.5 psi and it was loud as hell.

Cutting the coils sometimes causes them to leak.

 
Rep Power: 0

yeah I have heard of them leaking so I don't think I will cut any off thanks civic01vtech


a little off topic but civic01vtech are you going to the 4th annual mid-atlantic meet in VA Beach?

 
Rep Power: 607

prolly not, too far of a drive with the baby and i need to work.

 
Rep Power: 285

i cut the coils on mine, then heat treated part of the spring to make it progressive rate, then added a second, smaller but stiffer spring. Mine never leaked. Not even on 18 psi. Yet it would go off at any sign of vaccum, whether you were in boost or not.