can the housing be rotated?
Thread Starter
Registered!!
Joined: Oct 2003
Posts: 109
Likes: 0
From: las vegas
Rep Power: 0 
can the housing be rotated?
hey before i buy this turbo off ebay i was wondering if the compressor housing and the exhaust side of the turbo can be rotated so that where the charge pipe exits the compressor points straight down and the flange points straight up because all the tubos i have seen on ebay the flange points up and the compressor piping points towards the engine block???
this would make it hard to route piping myself thanx all-
this would make it hard to route piping myself thanx all-
Registered!!
iTrader: (5)
Joined: May 2001
Posts: 2,317
Likes: 0
From: PG county, MD, Maryland, US
Rep Power: 0 well if your just rotating it you shouldn't have to take the bolts all the way off
just loosen them enough to turn
if you buying a used one they might be a little tight so just put some
WD40 on them and if it comes to it
hit with a hammer
just loosen them enough to turn
if you buying a used one they might be a little tight so just put some
WD40 on them and if it comes to it
hit with a hammer
Thread
Thread Starter
Honda Civic Forum
Replies
Last Post
nola000
Engine start problems
63
Feb 17, 2023 09:18 PM
ThatGuy913
Mechanical Problems/Vehicle Issues and Fix-it Forum
6
Sep 28, 2015 05:35 PM
Styven Szastur
Fuel, Oil, Cleaners & Other Maintenance
4
Sep 23, 2015 05:26 PM
redcloud
I.C.E. (Audio) & Electrical Upgrades
9
Sep 7, 2015 01:45 PM
