Rep Power: 0

ok, i traded my axle-back (HKS) with ryans cat-back (Skunk2) and installed it today. when i lowered the car back down, i realized that the piping was too wide and that its extremely close to the ground (about an inch). my car is dropped about 2.25" and i dont want to raise it cuz it will mess up my alignment.

my question is, do you guys think the OEM midpipe will fit with the rear section of the skunk2 exhaust? or should i just get custom piping done? thanks in advance.

 
Rep Power: 0

I had the exact same problem with my magnaflow. Just do custom piping, thats what i did

 
Rep Power: 0

how big is your custom pipe? and how much did it cost?

 
Rep Power: 0

i would try the OEM 1st, then if un-happy do custom piping

 
Rep Power: 315

I would just get custom piping done...only about $75.00 for custom mandrel bent.