Rep Power: 0

I have a modded xbox with an xecuter 2 chip and external switch. The 5 wire cable that goes from the chip to the switch broke. My xbox does not work without this small cable. I checked all the xbox mod web sites and could not find a replacement wire. Is there anyone on the site that can knows where I can get a replacement wire or knows another way to fix this?

 
Rep Power: 289

how did it break off? im very familiar with the xecuter 2 as that its the same one I used for a couple of xbox projects.

 
Rep Power: 0

The 5 wire cable that goes from the chip to the switch broke off when it caught on the corner of the table. My dumb friend was moving it and not being careful.

 
Rep Power: 0

I can't seem to find any replacement cable for my version chip. Plenty of the 6 wire X2.6 lite's are available though.

 
Rep Power: 0

Is there any chip that I can just install in place of the one I have without reflashing the bios or messing with the software?

I really would just like to replace the cable but I'll do what I have to do to get it working again.

 
Rep Power: 289

u mean the plastic part where the wires are in or the part where the connector connects to the chip, cant u just stick it back?

 
Rep Power: 289

u can always solder it. just make sure its in the right place before soldering.

 
Rep Power: 0

All five of the wires broke off the plastic. I tried to solder it. It's to small. I ended up soldering all the wires together and melting the plastic piece.