Rep Power: 0

How do you think it will look to install 3 gauges in the dash panel about the glove compartment. Just use like a dremal to cut the hole size you need? let me know on your opinion. Im trying to think of a place to put the gauges. I dont want to put them on the piller.

 
Rep Power: 0

im having my buddy custom fabricate a guage pod for me...he does wonders with fiberglass...anyways, its going to be located above the cup holders, hanging below where your sterio is. I know it will probably get in the way for putting drink in my cup holders...but i dont let people drink in my car anyways.
If you want to hang for a while and see how mine turn out, my buddy says that after he does mine, it wont be hard for him to do more cause he will have the mold.
Just giving you an option.

 
Rep Power: 425

It doesn't get in the way of the cup holders at all, provided you recess it into the dash.

 
Rep Power: 0

looks pretty good

 
Rep Power: 0

O THING THE GAUGES IN THE DASH WOULD LOOK GOOD....MAKE SURE U TAKE YOUR TIME AND CUT IT EVEN!!!!!!!! THE DASH BOARD IS A VERY EXPENSIVE PEICE AND WILL COST ALOT IF U F@CK IT UP.....TAKE PIX WHEN YER DONE

 
Rep Power: 0

Boilermaker,
Im doing mine different from that...its kind of the same idea though.
I have foglights, so i want to keep that switch where it is....my guages are going to be hanging above the cup holders attached to the center dash right under where you hav the A/C button, the Rear window defrost button, and what not. Mine is also going to be a tri-pod.
I'll keep you guys updated