Rep Power: 0

got these on wednesday off ebay. hopefully going in tonight. pre sprayed the bolts with pb blaster and managed to get the heat shield off. i have a lx coupe and ive heard rumors of cutting i have 2 hours until a buddy is here so im going to just soak all the bolts with pb and hopefully it goes well




notice the "jdm" sticker haha

 
Rep Power: 0

im likin the JDM sticker... freakin gonna add 10HP easy

 
Rep Power: 256

i had to cut one of the bolts when i did my motor swap. bitch wasnt comin off for **** and i used half a can of pb. be very gentle and use the closed end of a wrench. no sockets or anything. where did you pick it up?

 
Rep Power: 0

yeah where did you pick it up .and do you hav ethe e-bay member i.d to see his merchandise if he has anymore

 
Rep Power: 0

zomk_speed wsa the guy. it took him 3 weeks to send it no email no tracking number. acually he did send the number 3 weeks after and by then it was here haha

 
Rep Power: 325

looks nice...

 
Rep Power: 325

and btw, these rumors u heard, i think that ive onlyheard them from HP race header.

 
Rep Power: 243

These? looks like one to me.

 
Rep Power: 0

when i read this......thought hes goin into somewhere else lol

 
Rep Power: 0

It's true that you have to grind a little on the subframe for the HP 4-1 racing header w/high flow cat to fit properly. When I first put their header on my civic, the lowest pipe was actually touching the subframe, sending all the vibrations straight to the steering wheel! After the RPMs got above 2000, the engine lifted up enough to clear the subframe. They are good headers, as the high flow cat helps some, but HP racing should have made the header a 4-2-1 design for better clearance.

 
Rep Power: 247

correct me , but arent you better off keeping it stock?