Hopefully going in tonight...
 

got these on wednesday off ebay. hopefully going in tonight. pre sprayed the bolts with pb blaster and managed to get the heat shield off. i have a lx coupe and ive heard rumors of cutting :shrug: i have 2 hours until a buddy is here so im going to just soak all the bolts with pb and hopefully it goes well
http://i35.photobucket.com/albums/d1...8/S4021270.jpg

http://i35.photobucket.com/albums/d1...8/S4021269.jpg

notice the "jdm" sticker haha

im likin the JDM sticker... freakin gonna add 10HP easy

i had to cut one of the bolts when i did my motor swap. bitch wasnt comin off for shit and i used half a can of pb. be very gentle and use the closed end of a wrench. no sockets or anything. where did you pick it up?

yeah where did you pick it up .and do you hav ethe e-bay member i.d to see his merchandise if he has anymore

zomk_speed wsa the guy. it took him 3 weeks to send it no email no tracking number. acually he did send the number 3 weeks after and by then it was here haha

looks nice...

and btw, these rumors u heard, i think that ive onlyheard them from HP race header.

These? looks like one to me.

when i read this......thought hes goin into somewhere else lol

It's true that you have to grind a little on the subframe for the HP 4-1 racing header w/high flow cat to fit properly. When I first put their header on my civic, the lowest pipe was actually touching the subframe, sending all the vibrations straight to the steering wheel! After the RPMs got above 2000, the engine lifted up enough to clear the subframe. They are good headers, as the high flow cat helps some, but HP racing should have made the header a 4-2-1 design for better clearance.

correct me , but arent you better off keeping it stock?