Need help ASAP! Put in a new clutch lastnight. Took flywheel to get resurfaced. They call me and tell me my flywheel is way off there specs . That it has a .137" cup and specs say it needs to be .065 for a d1.7a1. I didn't think twice clarified my engine and said to cut it to specs. Put it back together and my friction plate is just spinning the cut was way to deep . Car inoperable . Need to find out what flywheel was in it cause they said it should be a thinner one but the one I had worked just fine before they cut it down 3/4 of a inch . Need to find out what flywheel I had

Tranny says b6b and had an Exedy clutch kit before I changed it to one that lined up and matched and fit perfect