Rep Power: 0

Hi All

First post here but I'm an active member on S2KI and hope you guys won't mind helping a Honda brother out. I'm at work and trying to help a coworker replace the flasher in her '05... we've got the part but don't really have any tools here. Shouldn't need them for this quick replacement. I just can't seem to get the old one out-- it is like -8349028 degrees here in Wisconsin and the fingers don't work too well when they're frozen solid.

Is there a trick to it (clip on the back or something) or is it just a finesse thing?

Thanks for your help
chazzguitar

 
Rep Power: 308

It looks like a clip is coming up the side and may hold the top edge/corner, the clip should just move side-ways and release hold. The connectors may hold it tight as well

 
Rep Power: 811

on a 05 civic? mine just pulled out

 
Rep Power: 0

Thanks for the prompt replies. I did see that clip on the side (in between the flasher and the small fuse tray on the fuse board, yes?) but remember there being a little bump on another side of the housing and didn't know if that needed attention.

And no, it certainly hasn't pulled right out! Maybe I'm just a sissy...

Thanks again
chazzguitar

 
Rep Power: 308

Did you know the box will drop down if you take out the bolt at the bottom ??

IIRC I tried to remove mine once and it was tight (left it alone)

 
Rep Power: 0

Yep, got the box dropped down but not too far as the wiring to some of the harnesses at the top of the box is extraordinarily tight. Precision manufacturing for sure.